Ecolat rolled up Gray - 10M x 14CM x 0.7CM - ECOO pond border

The goal is to achieve a perfectly level pond edge and keep the liner as hidden as possible. This can be done using Ecolat® slats from ECOO.

Paths, lawns, flower beds and vegetable patches can also be landscaped in the same way with the Ecolat® edging.  

For curved shapes, Ecolat® edging is available in 25 m or 10 m rolls. It is flexible and ideal for freeform shapes. For straight ponds, it is available as a straight slat 2 or 3 m long.
Ecolat® slats are secured using Ecopic stakes with an H-profile. They are easy to drive into the ground and provide excellent stability.

Benefits:

• Eco-friendly: made 100% from recycled plastic waste
• Product made in Belgium
• Rot-proof: very long lifespan
• Rollable version: ideal for round shapes (not suitable for straight edges)
• Straight slat version: ideal for straight and clean shapes
• Easy to transport (rolls)
• Lightweight and easy to handle
• Suitable for path, lawn, flower bed, vegetable patch and pond edging
• Secured with Ecopic stakes for high stability

Easy installation:

ECOLAT POND EDGE

For a beautiful pond edge, it is important to position the Ecolat® slat perfectly level. It determines the water level in particular.

1. Drive the Ecopic stakes into the ground and secure the Ecolat® slat against the stakes.
2. Place a protective felt in the pond and on the Ecolat® edging. This felt protects the liner from anything sharp in the ground.
3. Then place the pond liner over the edge and finish it properly on the outside.

ECOLAT EDGING

Partially buried, Ecolat is securely fixed in the ground using Ecopic stakes.

1. Place Ecolat where the edging will eventually be. The Ecolat roll will then unroll. When installing, follow the folds of the roll.
2. Dig a trench and place Ecolat in it. Preferably place at least 2/3 of the Ecolat in the ground.
3. Drive the Ecopic stakes into the ground with a rubber mallet. The H-profile guarantees high stability. The stakes end approximately 3 cm below the top edge of Ecolat and are invisible once the work is finished. Depending on the type of application, place the stakes at least every 50 cm.
4. Secure Ecolat against the Ecopic stakes with stainless steel screws (2 per stake). A spirit level is a practical tool for a successful result.
5. Fill the side of the edging with soil, bark, stones, etc.