Ecolat rolled up Brown - 10M x 14CM x 0.7CM - ECOO pond border

The goal is to achieve a perfectly horizontal pond edge and to see a minimum of liner. This can be achieved using Ecolat® slats from ECOO.

Paths, lawns, flower beds, and vegetable gardens can also be laid out in the same way with the Ecolat® edging.

For curved shapes, Ecolat® edging is available on 25m or 10m rolls. It is flexible and ideal for free-form shapes. For straight ponds, it exists as a 2m or 3m long straight slat.
Ecolat® slats are fixed by means of Ecopic stakes with an H-profile. They are easy to drive into the ground and maintain high stability.

Advantages:

• Ecological: made from 100% recycled plastic waste
• Product made in Belgium
• Rot-proof: very long service life
• Flexible roll version: ideal for round shapes (not suitable for straight edges)
• Straight slat version: ideal for straight and clean-lined shapes
• Easy to transport (rolls)
• Lightweight and easy to handle
• Suitable for edging paths, lawns, flower beds, vegetable gardens, and ponds
• Fixed with Ecopic stakes, ensuring a high level of stability

Easy installation:

ECOLAT POND EDGE

For a nice pond edge, it is important to position the Ecolat® slat perfectly horizontally. It determines, among other things, the water level.

1. Drive the Ecopic stakes into the ground and attach the Ecolat slat against the stakes.
2. Place a protective felt in the pond and over the Ecolat® edging. This felt protects the liner from anything sharp in the ground.
3. Then place the pond liner over the edge and finish neatly on the outside.

ECOLAT EDGING

Partially buried, Ecolat is firmly fixed in the ground using Ecopic stakes.

1. Lay the Ecolat where the edging will finally be placed. The Ecolat roll will then unroll. When laying, follow the undulations of the roll.
2. Dig a trench and place the Ecolat in it. Preferably place at least 2/3 of the Ecolat in the ground.
3. Drive the Ecopic stakes into the ground with a rubber mallet. The H-profile guarantees high stability. The stakes should end up about 3 cm lower than the top edge of the Ecolat and are invisible once the work is finished. Depending on the type of application, place the stakes at least every 50 cm.
4. Fix the Ecolat against the Ecopic stakes with stainless steel screws (2 per stake). A spirit level is a handy tool for a successful result.
5. Fill the side of the edging with soil, bark, pebbles, etc.